Favorite Tips About How To Clean Starter Motor

Starter motor cleaning tutorial by robmack 1.

How to clean starter motor. Check direction of rotation before coupling motor to load. Difference before and after is not so noticeable on video like in real, it's so much better, even with more drained battery starter spins faster and engine s. How to clean a starter motor.

Remove the two bolts on the outer ends of the starter using a wrench or socket and ratchet. Usually, build ups in the starter can cause all sorts of problems and eventually shorting the life of the starter. Before starting motor remove all unused shaft keys and loose rotating parts to prevent them from flying off.

Allow scooter to sit for an hour and then retry. By spraying it with the cleaner and working a tooth brush over it and even a scotch bright pad, it cleaned up. If it is as low as 12.2 volts then charge the battery.

Thoroughly clean the bendix drive to remove all dirt and contamination from the screwshaft threads and control nut. You can see in the first shot how the muddy water has got in and rusted the parts. I disassembled this starter to clean out the build up using.

Put a volt meter on the battery, it should read, around 12.6 volts. Use only clean petroleum base cleaners such as kerosene or varsol. I always do this anytime i have a starter off.

The location of the starter motor can be differed by car models, the following instruction is the regular way to replace a starter solenoid. Alternatively, remove the spark plug and run a. Use the permanent marker to draw reference marks on both end caps and the stator housing of the motor.